DIY Acrylic Lighted Crystal Pillar Wedding Centerpiece | Super Affordable!!!

DIY Acrylic Lighted Crystal Pillar ideas are not simply for keeping within the budget for the big day, but also give you the WOW factor from your audience. With this easy step-by-step instructions, the Acrylic Lighted Crystal Pillar  wedding ideas can make your special day a much more memorable experience.

Take a look and follow with me as i show you how to create this masterpiece.

For more details, watch the full video:




Directions :

I am going to lay three of the acrylic sheets flat on a surface I will be using painters tape to tape between each of the acrylic sheets

Note : Make sure you align it correctly using the tape


To avoid messy all over the place I highly recommend to use a “little syringe applicator” to help you distribute the acrylic glue neat.

Remember : You do not need a lot of glue. A little glue goes a long way.

Once the other side is dry I leave it for about 30 minutes to dry


I’m adding the glue to the tip of the side

Note : Put just a small pea-sized to go along the sides

Then, embellish the top with bush lights and with some beautiful crystal garland

This is what it should look like

Now Test it with the push Light so you can see the amazing beauty

Put the Flower Arrangement on top for the Final look… It should look similar to this…

LIST OF ITEMS NEEDED…

Before You Buy them Click Here Sign up For A FREE Ebates Account  To Get Cash Back On All Your Purchase

Click On each Item To Get IT at Direct site …

Acrylic Cement, Low-VOC, Medium bodied, 5 Ounce Tube, Clear Glue

Applicator adhesives glue Syringe Blunt Tip Needle and Cap –

***Warning the Acrylic glue is super liquid try using it with an applicator bottle it will make the job a lot easier or put it in a small utensil and use a piece of stick to help apply it ***

1 9 x 9 Inches Acrylic Plexiglass Sheet, Clear: get cut to size at Lowes

4 9 x 24 Inches Acrylic Plexiglass Sheet, Clear : get cut to size at Lowes

Acrylic Plexiglass Sheet – Transparent, Plastic Sheeting size 9X24 ( Lowes or Amazon) But you can get the Acrylic Plexiglass in any size you want small big large. The plexiglass i used in the video was purchased from Loews for $10 after i got them to cut it to the desired size i wanted (9×24)

Big Push Light –

Small Push Light-

Syringe Blunt Tip Needle Applicator –

Glass Crystal Garland Chandelier –

Teardrop Crystal Pendants –

Loctite GO2 Glue All Purpose –

Crystal Rhinestone Ribbon, Sparkling Diamond Rhinestone Bling Ribbon Roll

If you enjoy the post, please share, and leave me a comment feedback in the comment section below.

Facebook Comments

1 thought on “DIY Acrylic Lighted Crystal Pillar Wedding Centerpiece | Super Affordable!!!”

  1. Wow what a beautiful piece! You gave me hope… I’m going to try it for my wedding centerpiece🥰
    Thanks for sharing this video, great job!

Leave a Reply

Your email address will not be published. Required fields are marked *